Angle beams contain two legs that converge at a right angle to one another to form an L-shaped structure. The two legs may have similar or different l...
Read more Design of T and L Beam in Flexure.
- Attic
- Basement
- Bathroom
- Bedroom
- Cabinets
- Carpentry
- Ceiling
- Cleaning
- Closets
- Concreting
- Countertops
- Decking
- Dining Room
- Doors
- Drainage System
- Driveway
- Fence
- Fireplace
- Flooring
- Furniture
- Garage
- Gardening
- Grill
- Home Decor
- HVAC
- Inspections
- Insulations
- Kitchen
- Laundry Rooms
- Lawn
- Lighting
- Living Room
- Masonry
- Painting
- Pathways & Sidewalks
- Patio
- Pest control
- Plumbing
- Porch
- Roofing
- Sheds
- Siding
- Smart Homes
- Solar panels
- Stairs
- Tiling
- Walls
- Windows
- Yards
- Farhan Khan
- May 6, 2020
A frame is a structure composed of several members that are either fixed–or pin–connected at their ends. It is often necessary to draw shear and m...
Read more Shear and bending Moment Diagrams for Frames
- Farhan Khan
- May 6, 2020
Frame structures combine beam, column and slab to resist the lateral and gravity loads. These structures are usually used to overcome the big moments ...
Read more Types of Frame Structures Rigid and frame structure
- Farhan Khan
- May 5, 2020
Background The problem in increasing the capacity of the beam is the restriction that As should not exceed Asmax. This places a restriction on the max...
Read more Design of Doubly Reinforced Beam in Flexure
- Farhan Khan
- May 5, 2020
Behavior of RC Beams Under Gravity Load Beam Test In order to clearly understand the behavior of RC members subjected to flexure load only, the respon...
Read more Design of Singly Reinforced Beam in Flexure
- Farhan Khan
- May 3, 2020
Standard Followed ASTM C 698 or AASHTO T-99 Objective The performance of standard proctor test targets the following objectives, To investigate the mo...
Read more Standard Proctor Test ASTM: D698-91 Apparatus, Procedure, Results
- Farhan Khan
- April 29, 2020
If only a few of the member forces are of interest, and those members happen to be somewhere in the middle of the truss, it would be very inefficient ...
Read more Analysis Of Trusses By Method Of Sections
- Farhan Khan
- April 29, 2020
The method of joints is one of the simplest methods for determining the force acting on the individual members of a truss because it only involves two...
Read more Analysis Of Trusses By Method Of Joints
- Farhan Khan
- April 29, 2020
Co-planar trusses are classified into three types which are Simple Truss Compound Truss Complex Truss Simple Truss The simplest framework that is rigi...
Read more Classification of Coplanar Trusses its Indeterminacy and Stability
- Farhan Khan
- April 28, 2020
Loading is the act of applying force to an object. The performance of a material depends on the loading conditions and can be subjected to a wide rang...
Read more Types of Loads on Building