Your home’s value will increase, and you will have seclusion thanks to vinyl fencing. It is not difficult to install vinyl fencing. Although it is also available as panels, vinyl fencing is most often found in pre-sized kits.
To fit your needs, vinyl panels are frequently excessively tall; in this situation, you will need to reduce them. Fencing made of vinyl is the best option. Vinyl fence panels don’t corrode, rust, decay, or yellow over time.
Vinyl is a low-maintenance fencing material. Painting is never essential because the paint won’t even adhere to vinyl. Compared to wood fences, vinyl fences are lighter and simpler to install.
Table of Contents
Steps To Cut Vinyl Fence Panel
1) Collect Needed Tools
The fence panels made of vinyl are simple to move. Use the same method when cutting your fence panels with a table saw. Instead of cutting the vinyl fence panel with a blade, you will need to shove the panel into the blade.
- Tape measure
- Circular saw
- Chalk
- Duct tape
2) Measure The Fence
Use a measuring tape to establish the desired fence height and proceed to the area of your yard where you intend to put the vinyl fencing. When installing it, you must bury the vinyl fencing posts deeper than you would for metal or wood.
Before measuring the fence, this extra depth needs to be calculated. Make use of the measurements and use the chalk line to mark the points on the fence. So, you can see where the line needs to be cut. To account for the rail hangers, add a half-inch extra.
3) Use Circular Saw For Cutting The Vinyl Fence
No matter how many teeth are on the circular saw blade, cutting vinyl fencing can be challenging since it is frequently hollow. The teeth’s bite on the vinyl causes it to vibrate and shake. This may cause the vinyl to fracture and crack.
You must maintain the components’ stability to stop this from happening. Set the first item for cutting on the work surface. Once it is in position, you may mount one on either side of the vinyl piece to create a sandwich. The vinyl component will remain in place as a result.
4) Use A Blade Guide For Proper Cutting
The vinyl parts can still be torn apart and shredded even though they are firmly fastened. Align the blade guide and the chalk line. Turn it on after ensuring your hands are not around or near the saw.
Bring the blade down gradually to the vinyl once it has reached its maximum speed. As the blade is lowered to the vinyl, secure it with your hand before letting it do its work. Keep the blade moving throughout the cut rather than rushing it to avoid damaging the vinyl. Continue in this manner until you have completed the project.
Once the vinyl fence parts have been cut and are prepared for installation, continue cutting through them. The vinyl fence panel will be entirely cut through if you turn on the saw and bring the revolving blade down onto it. Turn off the saw by raising the blade.
5) Wrap The Cracked Fence With Duct Tape
When installing cut vinyl fencing, you must exercise caution because even the smallest crack can damage the fence completely. The bottom of the sections that will be buried should be wrapped with duct tape, and the cut edges should be lightly sanded.
Is It Possible To Cut Vinyl Fence With A Handsaw?
Circular saw blades made exclusively to cut vinyl are produced by several businesses. A hand saw is quite inexpensive, DIYers already have one in their toolbox, but it will require a little more attention and effort. To achieve the greatest results, make sure your hand saw is razor-sharp.
Using a good blade and little effort will accomplish the task, but it will take longer and result in a less precise cut than a circular saw. After that, you can invest some money in a quality puzzle for later usage.
However, the best instrument for cutting vinyl siding is often a utility knife. A hand saw, or a pair of tin snips is the best tool to use if you need to make a few vertical cuts.
